Modifications

FraiseuseCNC/restauration

708 octets ajoutés, 7 février 2013 à 16:26
CNC_pycamgrBL
Il reste à corriger l'orientation des axes X et Z (re-compilation du firmware ?) pour pouvoir balancer du GCode.
 
$0=29.400 (x, step/mm)
$1=29.300 (y, step/mm)
$2=196.000 (z, step/mm)
$3=30 (step pulse, usec)
$4=8000.000 (default feed, mm/min)
$5=8000.000 (default seek, mm/min)
$6=0 (step port invert mask, int:00000000)
$7=25 (step idle delay, msec)
$8=10.000 (acceleration, mm/sec^2)
$9=300.000 (junction deviation, mm)
$10=0.100 (arc, mm/segment)
$11=25 (n-arc correction, int)
$12=3 (n-decimals, int)
$13=0 (report inches, bool)
$14=1 (auto start, bool)
$15=0 (invert step enable, bool)
$16=0 (hard limits, bool)
$17=0 (homing cycle, bool)
$18=0 (homing dir invert mask, int:00000000)
$19=25.000 (homing feed, mm/min)
$20=250.000 (homing seek, mm/min)
$21=100 (homing debounce, msec)
$22=1.000 (homing pull-off, mm)